Compressor

The Compressor effect is used to reduce the dynamic range of an audio signal - make quiet sounds louder, and loud sounds quieter. AVS Audio Editor will apply the Compressor effect along with the Noise Gate filter. This will help get rid of unnecessary noise by eliminating audio signal below the specified threshold.

Use the Play buttons to listen to and compare the sound before and after applying the Compressor effect:

How to Apply

All effects and filters are applied in the same way in AVS Audio Editor. For detailed step-by-step instructions on how to apply effects to your audio files, click here.

Compressor Settings

The Compressor effect allows to configure the following parameters:

Compressor Parameters

The following compressor parameters are available for editing:

• Threshold - the level (in dB) at which the compressor becomes active. The compressor will affect only the sound above the specified threshold.
• Ratio - the amount of compression of the output signal in relation to the input audio. Setting the compression ratio to 1:1 will produce no compression effect. If you set ratio to 1:3 and threshold to -20, a -2 dB sound will be compressed down to -14 dB (the difference between -20 and -2 will be divided by 3).
• Attack Time - the period during which the compressor becomes active and decreases gain till it reaches the specified ratio.
• Release Time - the period during which the compressor remains active once the sound has fallen below the threshold.

Note: the attack and release times are used to smooth the compressor boundaries. The slower the attack and release are, the smoother the transition between affected and non-affected signal will be.

Noise Gate Parameters

The following Noise Gate parameters are available for editing:

• Threshold - the level (in dB) at which the gate opens. The noise gate filter will affect only the sound below the specified threshold.
• Attack Time - the amount of time it takes the noise gate to change from closed to open once the signal exceeds the specified threshold.
• Release Time - the period during which the noise gate remains open once the signal has fallen below the specified threshold.

Note: the attack and release times are used to smooth the noise gate boundaries. The slower the attack and release are, the smoother the transition between affected and non-affected signal will be.

General Options

The following general parameters are available for editing:

• Post-Amplify - the amount of post-amplification used after the compressor has been applied. This will allow you to restore the original sound level after applying the compressor.
• RMS/Peak - a method of measuring the sound level. Tick the corresponding radiobutton to select the desired method.
• Equal gain for channels - allows to synchronize channels; the compression and noise suppression ratios, as well as the moments of noise gate opening will be the same for all channels.